Deutsch
français
español
русский
Dosing pump Dosi-Pump 4 ml
- Medium-contacting parts made of PP, PE and stainless steel
Packaging unit
Piece
Detailed information
Standard dosage approx. 4 ml per stroke.
Dosing pumps are mounted by you in your existing container closure (see the locating bore table). To do this, a suitable hole is drilled in the cap. Then the pump is inserted through the hole and screwed in place from below.
A matching container connection is not included in the scope of delivery.
Typical application area of the product
Dosing pumps suitable for barrels, canisters, carboys or bottles, for dosing liquids of different viscosities.
- Dosing pump Dosi-Pump 4 ml
Specifications
General material
PP
Polypropylene
General material
PE
Polyethylene
Further materials
1.4301 (AISI 304)
Stainless steel (1.4301), AISI 304
Further materials
PE-LD
Low-density polyethylene (LDPE)
Further materials
EPDM
Ethylene propylene diene monomer rubber
Delivery tube
- Immersion depth max.:
- 20.5 cm
Throughput
- Conveying capacity:
- 4 ml/stroke
Connection
- Connection Ø:
- 21 mm
Ø
- Pipe Ø:
- 8.5 mm
- Immersion tube Ø:
- 8.5 mm
Pump outlet
- Length of discharge tube:
- 42 mm
- Outer outlet Ø:
- 8 mm
Colouring
- Colour:
- weiss
Limit values
- Viscosity up to:
- 2200 mPa·s
Similar products
Dosing pump Dosi-Pump 30 ml
Standard dosage approx. 30 ml per stroke.
Dosing pump Dosi-Pump 30 ml, fixed feeding tube
Standard dosage approx. 30 ml per stroke, the pump has a fixed feeding tube.
Dosing pump Dosi-Pump 100 ml, fixed feeding tube
Standard dosage approx. 100 ml per stroke, the pump has a fixed feeding tube.
Dosing pump Dosi-Pump 250 ml, fixed feeding tube
Standard dosage approx. 250 ml per stroke, the pump has a fixed feeding tube.